System Toolbox; User Codes; User Code Setup; Adding A User Code - 2gig Technologies GO!control 2GIG-CNTRL2 Operation And User's Manual

System Toolbox

User Codes

The system installer has pre-programmed a Master User code for your system. This code can be used
to control the system, as well as assign and change the other seven User Codes. The Master User
Code can also access several system setup settings in the User Toolbox. The other seven User Codes
are restricted from those settings in the User Toolbox.

User Code Setup

Only the person with the Master User Code can add or change the other User Codes.
To setup the User Codes, use the following
steps:
1. On the Home Screen, press
2. On the Security Screen, press
3. On the Menu Screen, press
4. On the Toolbox Screen (1 of 3),
press USER CODES.
5. Enter the Master User Code
(the factory setting is 1111).
6. The Users Screen displays three
users at a time. Use the ↓ and ↑
arrows to scroll through the list.

Adding a User Code

✓ NOTE: User Codes 0000 and 0001 are
not permitted.
1. Press one of the
2. Enter a four-digit code for the
new User Code and press OK.
3. Enter the Code again to confi rm
the code and press OK.
4. A confi rmation screen will
display, press OK.

Changing a User Code

1. Press one of the
USER buttons.
2. Press CHANGE USER PIN.
3. Enter a new four-digit code for
the User Code and press OK.
4. Enter the Code again to confi rm
the code and press OK.
5. A confi rmation screen will
display, press OK.
28
SECURITY.
MENU.
TOOLBOX.
ADD USER buttons.
CHANGE
Toolbox Screen 1
Users Screen
User Code Entry Screen
Change / Delete User Screen