Cell Phone Test - 2gig Technologies GO!control 2GIG-CNTRL2 Operation And User's Manual

Cell Phone Test

Your security system may be equipped with a built-in cellular radio. The cellular radio communicates
between your security system and the Central Monitoring Station. Your system can send its alarm
messages and system trouble or status messages over-the-air without using the land-based
telephone system. The cellular radio also can receive messages and system updates from the
Central Monitoring Station. Audio communications with the Central Monitoring Station can also
occur through the optional cellular radio.
The system toolbox contains provisions for testing the cellular radio module inside your system.
★ IMPORTANT: TEST YOUR SECURITY SYSTEM WEEKLY TO ASSURE CONTINUED
PROTECTION AND PROPER SYSTEM OPERATION.
To test the cellular radio, use the following
steps:
1. On the Home Screen, press
2. On the Security Screen, press
3. On the Menu Screen, press
← and → arrows to
4. Use the
select Toolbox Screen (3 of 3).
5. On the Toolbox Screen (3 of 3),
press CELL PHONE TEST.
6. Enter the Master User Code
to begin the test.
The system will display the test status screen.
The top part of the screen shows each function
that is being tested. Use the ↑ and ↓ arrows to
scroll through the status messages. The bottom
part of the screen shows the results of each
test.
If any tests fail, note what messages were
displayed, and contact your alarm installer. Your
installer will be able to diagnose any possible
issues with your system.
After the testing is complete, press OK to return
to the Toolbox.
SECURITY.
MENU.
TOOLBOX.
System Toolbox
Toolbox Screen 3
Cell Phone Test Code Entry
Cell Phone Test Status
33