If A Burglary Alarm Occurs; Burglary Alarm Siren; Alarm Memory; Optional 2-Way Voice Communications - 2gig Technologies GO!control 2GIG-CNTRL2 Operation And User's Manual

Burglary Protection

If a Burglary Alarm Occurs

If an armed sensor is tripped while the system is armed in the Stay or Away Mode, and the system
is not disarmed in time, an alarm will occur and the siren will sound. Delayed sensors will start
the Entry Delay to allow time to disarm the system. Instant sensors trigger the alarm right away.
Most sensors will trigger the alarm siren, some sensors may be set to trigger a silent alarm without
sounding the siren.

Burglary Alarm Siren

If there is a burglary alarm tripped while the system is armed, the Control Panel will sound the alarm
siren for a preset time (the time can be changed; see the Installer Set Options section of this manual).
After the time expires, the siren will stop sounding. The system can also be set by the installer to
allow one or two alarm cycles per sensor, per arming period.

Alarm Memory

If an alarm has occurred while the system was armed, the Disarm Screen will show the time and date
of the alarm and the sensor(s) that triggered the alarm.
After the system is disarmed, the Alarm Memory screen will be displayed. The Alarm Memory Screen
shows the sensor(s) that have caused the alarm. If more than one sensor has been triggered, the
display will show the order that alarms occurred. The alarm memory will automatically clear
the next time the system is armed. You can also check the CLEAR ALARM HISTORY button and
press OK to manually clear the alarm memory (24-hour sensors that are still violated will remain in
alarm memory).
Disarm Screen Showing Alarms
Alarm Memory Screen
Anytime there are events stored in alarm
memory, the Security Screen will display the
button. The number on the button is the
number of sensors that triggered during the
alarm. Press the button to view the Alarm
Memory Screen.
Security Screen with Alarm Memory Button

Optional 2-Way Voice Communications

2-way voice communications provides a method for alarm verifi cation and can provide emergency
assistance. The Control Panel contains a built-in microphone that can monitor sounds around the area
of the Control Panel. The built-in microphone and speaker allows 2-way voice communications with
a Central Station operator after an alarm. The operator can converse with people in the premises
through the Control Panel's speaker and microphone.
Your installer can set the system to use 2-way voice communications after an alarm and/or after a
panic alarm is triggered.
✓ NOTE: If a panic alarm or sensor is set for a silent alarm, the operator will only be able
to listen and not be able to talk. This is for your protection.
15