Table of Contents
Advertisement
5.
Remove the display assembly (2).
Reverse this procedure to install the display assembly.
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Solid-state drive connector board cable (see
b.
Card Reader board cable (see
c.
Top cover (see
d.
WLAN module (see
e.
Wireless audio module (see
68
Chapter 4 Removal and replacement procedures
Battery on page
33), and then remove the following components:
Card Reader board cable on page
Top cover on page
40)
WLAN module on page
Wireless audio module on page
Solid-state drive on page
37)
53)
51)
Spare part number
687530-001
35)
Advertisement
Table of Contents
