Power Connector Cable - HP ENVY x360 Maintenance And Service Manual

Table 5-3 Speaker description and part number
Description
Speakers (includes left and right speakers, cables, and four rubber isolators)
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the speakers:
1. Disconnect the speaker cable (1) from the system board.
2. Release the speaker cables from the retention clips (2) that are built into the battery and the
computer.
3. Remove the speakers (3) from the computer.
NOTE:
absence of or damage to these isolators can result in degraded speaker performance.
To replace the speakers, reverse the removal procedures.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 5-4 Power connector cable description and part number
Description
Power connector cable (includes cable and connector):
NOTE: The power connector cable spare part kit does not include the power connector cable
bracket. The power connector cable bracket is not available as a spare part.
Bottom cover on page
When removing the speakers, make note of the location of the four rubber isolator (4). The
Preparation for disassembly on page
30).
Battery on page
Spare part number
N41021-001
30).
31).
Spare part number
N45022-001
Power connector cable 33