Table of Contents
Advertisement
Hinge covers
Description
Hinge covers
Before removing the hinge covers, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Solid-state drive connector board cable (see
b.
Card Reader board cable (see
c.
Top cover (see
d.
WLAN module (see
e.
Wireless audio module (see
f.
System board (see
Remove the hinge covers:
1.
Remove the four Phillips PM2.0×3.8 screws (1) that secure the hinge covers to the base enclosure.
Battery on page
33), and then remove the following components:
Card Reader board cable on page
Top cover on page
40)
WLAN module on page
Wireless audio module on page
System board on page
Solid-state drive on page
53)
51)
57)
Component replacement procedures
Spare part number
672009-001
35)
37)
65
Advertisement
Table of Contents
