Solid-State Drive - HP Spectre Ultrabook PC Maintenance And Service Manual

Solid-state drive

Description
256-GB SATA III solid-state drive
128-GB SATA III solid-state drive
128-GB SATA II solid-state drive
Before removing the solid-state drive and cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (2) that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
2. Remove the solid-state drive by pulling the drive away from the slot at an angle (2).
NOTE:
the solid-state drive slot.
Battery on page
The solid-state drive is designed with a notch to prevent incorrect installation into
33).
Component replacement procedures
Spare part number
698645-001
697235-001
675508-001
35