Reverse this procedure to install the top cover.
Solid-state drive connector board
Description
Solid-state drive connector board (includes cable)
Before removing the solid-state drive connector board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Solid-state drive connector board cable (see
b.
Card Reader board cable (see
c.
Top cover (see
Remove the solid-state drive connector board:
1.
Turn the top cover upside down, with the front toward you.
2.
Remove the Phillips PM2.0×3.6 screw (1) that secures the solid-state drive connector board to
the top cover.
44
Chapter 4 Removal and replacement procedures
Battery on page
33), and then remove the following components:
Card Reader board cable on page
Top cover on page
40)
Solid-state drive on page
37)
Spare part number
675509-001
35)