Table of Contents
Advertisement
Power connector and cable
Description
Power connector and cable
Before removing the power cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4.
Remove the following components:
a.
Service door (see
b.
Hard drive
c.
Keyboard (see
d.
Top cover (see
e.
Battery (see
f.
Display assembly (see
Remove the power cable:
1.
Disconnect the cable from the system board (1).
2.
Remove the cable from the clip in the computer (2).
3.
Remove the power cable from the computer (3).
Reverse this procedure to install the power cable.
82
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service doors on page
(Hard drive on page
34)
Keyboard on page
43)
Top cover on page
50)
Battery on page
62)
Display assembly on page
32).
75)
Spare part number
905644-001
Advertisement
Table of Contents
