Wireless audio module
Description
Wireless audio module
Before removing the wireless audio module, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Solid-state drive connector board cable (see
b.
Card Reader board cable (see
c.
Top cover (see
Remove the wireless audio module:
1.
Disconnect the wireless audio module antenna cables (1) from the terminals on the wireless
audio module.
NOTE:
"Main" terminal. The #8 wireless audio module antenna cable is connected to the wireless
audio module "Aux" terminal.
2.
Remove the Phillips PM2.0×3.8 screw (2) that secures the wireless audio module to
the system board. (The wireless audio module tilts up.)
Battery on page
Top cover on page
The #7 wireless audio module antenna cable is connected to the wireless audio module
33), and then remove the following components:
Solid-state drive on page
Card Reader board cable on page
40)
Component replacement procedures
Spare part number
672011-001
35)
37)
51