HP Spectre Ultrabook PC Maintenance And Service Manual page 49

5. Remove the solid-state drive connector board cable (see
6. Remove the Card Reader board cable (see
NOTE: When replacing the top cover, be sure to remove the following components from the defective
top cover and install them on the replacement top cover:
●
NFC board (see NFC board on page
●
Solid-state drive connector board (see
●
Card Reader board (see
●
Power button board (see
Remove the top cover:
1. Release the ZIF connector to which the TouchPad cable is connected, and then disconnect
the TouchPad cable (1) from the TouchPad.
2. Disconnect the speaker cable (2) from the system board.
3. Remove the two rear rubber feet (1).
Card Reader board cable on page
38)
Card Reader board cable on page
Card Reader board on page
Power button board on page
Solid-state drive on page
37)
45)
46)
Component replacement procedures
35).
37).
41