3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Solid-state drive connector board cable (see
b.
Card Reader board cable (see
c.
Top cover (see
Remove the power button board:
1.
Turn the top cover upside down, with the front toward you.
2.
Remove the Phillips PM2.0×3.6 screw (1) that secures the power button board to the top cover.
3.
Remove the power button board (2) and cable.
Reverse this procedure to install the power button board.
Battery on page
33), and then remove the following components:
Card Reader board cable on page
Top cover on page
40)
Solid-state drive on page
37)
Component replacement procedures
35)
47