Table of Contents
Advertisement
Remove the display assembly:
1.
Disconnect the webcamera/microphone module cable (1) from the system board.
2.
Disconnect the display panel cable (2) from the system board.
3.
Release the display panel cable (3) from the heat sink. (The display panel cable is attached to
the heat sink with double-sided tape.)
CAUTION:
Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other
computer components.
4.
Remove the six Phillips PM2.5×5.6 screws (1) that secure the display assembly to
the base enclosure.
Component replacement procedures
67
Advertisement
Table of Contents
