Xerox WorkCentre 3045 User Manual page 177

Symptom
The printed output is foggy.
Auger marks appear on the printed
output.
The output print is wrinkled or
stained.
Envelopes are wrinkled or creased
when printed.
Solutions
Clean the developer. For details, see
• Use PrintingScout to check the toner level. If the toner cartridge is near
empty, replace it.
• Verify that the toner cartridge is approved for use in this printer, and
replace it as needed. For best results, use a genuine Xerox
cartridge.
• Clean the developer. For details, see
• Verify that the paper is the correct size, type, and weight for the printer
and that it is loaded properly. If not, change the paper.
• Change the Paper Type settings in the print driver.
In the Printing Preferences of the print driver, on the Paper/Output tab,
change the Paper Type setting.
Check if the crease is within 30 mm of the four edges of the envelope.
• If yes, it is printing as expected. Your printer is not faulty.
• If not, take the following actions:
For Number 10 envelopes, which are 220 mm or longer and have a flap
along the long edge, rotate the envelope 180 degrees.
For C5 envelopes, which are 220 mm or longer and have a flap along the
short edge, load them with the flaps open, facing up.
For Monarch or DL envelopes, which are shorter than 220 mm, load
them long-edge feed with the flaps open and facing up.
If the problem persists, use a different size envelope.
Cleaning the Developer
Cleaning the Developer
WorkCentre 3045 Multifunction Printer
Troubleshooting
on page 152.
®
toner
on page 152.
177
User Guide