Values In Inches - Canon IMAGERUNNER 2030 i Reference Manual

Values in Inches

If you want to enter values in inches in all modes which require a numeric entry, set
Inch Entry to 'On' in Common Settings (from the Additional Functions screen). (See
"Inch Entry," on p. 4-28.) This enables you to enter values in inches when you press
[Inch] on a screen requiring a numeric entry or measurement.
The default entry mode for numeric values is inches, but you can change it to
millimeters by turning the Inch Entry mode 'Off'.
The following example shows you how to enter 5 1/2" for the X (horizontal) value
when specifying an irregular paper size.
1
Press [5] ➞ [_] ➞ [1] ➞ [/] ➞ [2] using the numeric keys on the
touch panel display.
The entered values are displayed, as shown above.
NOTE
•
If you make a mistake when entering values, press [C] on the touch panel display
➞ enter the correct values.
•
You can enter only 2, 4, 8, or 16 as the denominator.
•
The value entered in inches is converted to millimeters by the machine each time it
is entered. Thus, there may be a slight difference between the value calculated and
the actual value entered.
•
To enter values in millimeters, press [mm].
Entering Characters from the Touch Panel Display
2
2-21