Standard Paper For The Stack Bypass - Canon IMAGERUNNER 2030 i Reference Manual

4
4

Standard Paper for the Stack Bypass

You can set the paper size and type that the stack bypass uses beforehand. This
setting is useful if you always load the same paper size and type into the stack
bypass.
If the Stack Bypass Standard Settings are stored when using the Send function,
you can also use the stack bypass to receive I-fax or fax documents.
IMPORTANT
When printing on special types of paper, such as heavyweight paper or transparencies,
be sure to correctly set the paper type, especially if you are using heavyweight paper. If
the type of paper is not set correctly, it could adversely affect the quality of the image.
Moreover, the fixing unit may become dirty and require a service repair, or the paper
could jam.
NOTE
•
If you are using the stack bypass as a paper source for Copy and Receive (I-fax or fax),
you must select the stack bypass when specifying the Drawer Eligibility for APS/ADS
setting. (See "Auto Paper Selection/Auto Drawer Switching," on p. 4-30.)
•
The default setting is 'Off'.
1
4-42
Specifying Common Settings
IMPORTANT
•
If a certain tray reaches its stacking limit, the machine automatically uses another
tray that is designated for the same function. However, it is recommended that you
only designate one tray for I-fax or fax documents to prevent them from getting lost.
•
If the optional Finisher-U2 is attached and the Staple mode is set, the sheets are
output to Tray A, regardless of the Tray Designation settings.
•
If the optional Finisher-U2 is attached and any of the following paper types is
selected, the sheets are output to Tray A, regardless of the Tray Designation
settings:
- Nonstandard paper size stock, envelopes, heavyweight paper, transparencies, or
labels.
Press [Done] repeatedly until the Basic Features screen
appears.
(Additional Functions) ➞ [Common Settings].
Press
If necessary, see the screen shot in step 1 of "Initial Function at Power ON," on
p. 4-17.