Canon IMAGERUNNER 2030 i Reference Manual page 181

4
4-46
Specifying Common Settings
NOTE
•
If you make a mistake when entering values, press [C] on the touch panel display
➞ enter the correct values.
•
For more information on entering the values in inches, see "Values in Inches," on
p. 2-21.
•
To enter values in millimeters, press [mm].
•
When entering the value in millimeters, you can also use
and (Clear) to clear your entry.
•
When entering the value in millimeters, you can also change the value by pressing
[-] or [+] in increments of 1.0 mm, even if you have entered the value.
•
You can use values for [X] between 5 7/8" (148 mm) and 17" (432 mm), and for [Y]
between 3 3/4" (95 mm) and 11 11/16" (297 mm).
❑
Press [Next]
❑
Select the desired paper type ➞ press [OK].
IMPORTANT
•
When printing on special types of paper, such as heavyweight paper, be sure to
correctly set the paper type, especially if you are using heavyweight paper. If the
type of paper is not set correctly, it could adversely affect the quality of the image.
Moreover, the fixing unit may become dirty and require a service repair, or the
paper could jam.
•
If you select [Irreg. Size], you cannot use the Rotate Collate, Rotate Group, Offset
Collate, Offset Group, Staple, 1 2-Sided, 2 2-Sided, Book 2-Sided, Two-page
Separation, or Image Combination mode. (See Chapter 5, "Appendix," in the
Copying Guide.)
NOTE
For more information on paper types, see "Available Paper Stock," on p. 2-44.
- (numeric keys),