Canon IMAGERUNNER 2030 i Reference Manual page 185

3
4
4
4-50
Specifying Common Settings
Select [Speed] or [Print Side] for each paper source ➞ press
[OK].
Details of each item are shown below.
[Speed]: When you feed one- or two-sided prints into the machine, the
method for delivering paper inside the machine changes, and this
affects the printing speed. Therefore, to maximize the printing
speed, load the paper manually as follows:
One-Sided Prints: Load the paper face up in a paper drawer, or face down
into the stack bypass. The side facing up in the paper
drawer, and the side facing down in the stack bypass are
the sides printed on.
Two-Sided Prints: Load the paper face down in a paper drawer, or face up in
the stack bypass. The side facing down in the paper
drawer, and the side facing up in the stack bypass are the
first sides that are printed on.
[Print Side]: If you load paper in a paper drawer and select [Print Side], no
matter whether you are printing one- or two-sided prints, the side of
the paper facing down is always the one printed on first. (The side
facing up is the one printed on first for the stack bypass.) However,
some speed will be sacrificed when printing one-sided prints.
If [Print Side] is selected for a paper source, and Drawer Eligibility For APS/ADS
in Common Settings (from the Additional Functions screen) is set to 'On', the
Automatic Paper Selection and Automatic Drawer Switching settings are ignored.
Also, the machine's printing speed may become slower when you print
one-sided documents.
The selected mode is set.
Press [Done] repeatedly until the Basic Features screen
appears.