Writing Down The Adjustment Values Of The Controller Pcb Assembly On The Service Label(Inner Finisher-G1) - Canon imageRUNNER ADVANCE C3330 Series Troubleshooting Manual

Copier Color | iR-ADV C3330/C3325/C3320 Series |
Writing down the adjustment values of the controller PCB
assembly on the service label(Inner Finisher-G1)
[Symptom]
When replacing the controller PCB assembly in Inner Finisher-G1, the adjustment values need to be readjusted to the values
saved on the previous PCB. For this purpose, a service label is newly set up as a service part. The adjustment values can be
written down on the label and the label can be attached to Inner Finisher-G1. Due to this change, the shape of the rear cover of
Inner Finisher-G1 is changed so the service label can be attached.
[Cause]
-
[Service work]
Upon service visit, if necessary, prepare the service label (FL1-1195-000) and the list of factory adjustment values attached to
this Service Information and follow the steps below.
The steps described below start after the finisher is removed from the engine.
1) Check the serial number of the Inner Finisher-G1 and write down the adjustment values of the applicable serial number from
the list of factory adjustment values on the service label.
2) Attach the service label on the rear cover.
[Reference] Attach the service label [1] in the designated area using the guidelines [2] on the rear cover.
3) Install the finisher to the engine.
When replacing the controller PCB assembly in Inner Finisher-G1, turn on the power, enter Service Mode and input the adjustment
values written down on the service label in the step 1)
[Attached file]
Factory adjustment values
[Service parts]
No.
1 Old -
New FL1-1195-000
2 Old FE3-6082-000
New FE3-6082-010
[Countermeasure cut-in serial numbers in factory]
Model
Part Number
Serial number
191
Description
-
LABEL, SERVICE
COVER, REAR
COVER, REAR