1.3.2 Operating System Independent SpeedTouch™
Supported Systems
Prerequisites
SpeedTouch™
Easy Setup
E-DOC-CTC-20040907-0001 v1.0
Configuration Setup
As the SpeedTouch™ is OS-independent, this configuration setup can be used from
any computer system.
Make sure that:
The SpeedTouch™ device is correctly set up and turned on as described in
"1.2 Setting up the SpeedTouch™" on page
The SpeedTouch™ device is in its default configuration state.
See
"5.2 SpeedTouch™ Default Configuration" on page 74
device.
The computer's Operating System supports TCP/IP and it's Ethernet interface
is configured for obtaining its IP configuration dynamically.
In case of problems with DHCP you can also configure the computer's
Ethernet or USB interface with a static Net10 private IP address, e.g.
10.0.0.1, 10.0.0.2, but make sure NOT to use the 10.0.0.138 IP address
as this is the default IP address of the SpeedTouch™.
Your web browser is able to run Javascripts.
SpeedTouch™ Easy Setup consists of two parts:
Configuration of the SpeedTouch™
Additional configuration
11.
(if needed)
Chapter 1
SpeedTouch™ Installation
for resetting your
23