NAPT
E-DOC-CTC-20040907-0001 v1.0
Clicking this button displays the Network Address and Port Translation (NAPT)
page.
This page allows you to:
View or add/delete specific static NAPT entries:
To add static NAPT entries proceed as follows:
1
Click New.
2
Specify the outside address and inside address for the entry as well as the
protocol and port to which the entry applies.
If the NAPT entry is applied to a connection's dynamically assigned
local peer IP address, you should specify 0.0.0.0 as the outside
address.
3
Click Apply to add the entry to the table.
View or add/delete Multinat Entries:
To add Multinat Entries proceed as follows:
4
Click New.
5
Specify the inside address and put the desired range between brackets e.g.
10.0.0.[1-10]. Specify the outside address and interface.
6
Click Apply.
Chapter 3
SpeedTouch™ Web Interface
51