Table of Contents
Advertisement
Requirements
Minimum Switch Configuration
An OmniAccess 6000 Wireless LAN Switch must include the following basic
components (as shown in
One modular Wireless LAN switch chassis
One fan tray
One supervisor card in Slot 0
One line card in Slot 2
Adequate power supplies
N
—The number and type of power supplies required depends on the number and
OTE
type of line cards installed in the chassis (see
In most cases, the Alcatel Wireless LAN Switch is shipped with all required
modules installed. If you have received your modules separately, first install
the chassis as described in this chapter, and then see Part 2 of this manual for
instructions on installing each additional module.
Rack Mounting Kit
Using the included rack mounting kit, the Alcatel Wireless LAN Switch can be
mounted in a standard 19-inch network equipment rack. The rack mounting
kit contains the following parts:
Left
Bracket
F
IGURE
N
—The six 12-24 screws are intended for securing the switch to the rack.
OTE
Some racks require different screws which are not included. Verify that you
have the correct screws or fasteners for your rack system before attempting
to mount the switch.
Figure 1-1
on
page
O T
O T
O T
S L
S L
S L
6-32 Flat Head
3
3
Screws
O T
O T
O T
S L
S L
S L
1
1
12-24 Screws
Right
Bracket
2-1 Rack Mounting Kit
2):
"Power Management"
x 8
x 6
Chapter 2
on
page
27).
Installing the Chassis
7
Advertisement
Table of Contents
