Table of Contents
Advertisement
OmniAccess 6000: Installation Guide
Module Indicator LEDs
4
A
Power LED
This LED is green when the line card is properly installed and the system is
powered up.
B
Status LED
During operation, the Status LED provides the following information:
Status
Off
Green
Amber
Red
5
Access Point Status LEDs
Each LED represents the status of APs connected to a specific port on the
switch. During operation, the LEDs provide the following information:
Status
Red (solid)
Red (flashing) An air monitor on this port has detected an unsecured AP .
Green
(flashing)
Amber (solid)
Green (solid)
Off
The LED states in
lowest). If more than one AP is connected to the port, the state with the
highest precedence is displayed.
48
Part 031639-00
T
7-3 Line Card Status LED
ABLE
Description
The line card is powered off or initializing.
The line card is operating properly.
The line card is being initialized.
The line card has failed.
T
7-4 Line Card AP Status LED
ABLE
Description
An AP on this port has failed (highest precedence).
The AP is attached to your network but is not listed in the
switch security policies. If security policies are enabled,
clients are not granted access to your network through the
unsecured AP .
An air monitor on this port has detected interference. The
interfering device (AP or other radio source) has been
detected by your valid APs, but has no wired presence on
your network.
Load balancing is enabled on this port or an AP has reached
the maximum number of clients it is configured to support.
All detected APs on this port are operating as expected.
No AP is detected on the port (lowest precedence)
Table 7-4
are listed in order of precedence (highest to
May 2005
Advertisement
Table of Contents
