Table of Contents
Advertisement
OmniAccess 6000: Installation Guide
N
—Use of a power line conditioner or Uninterruptable Power Supply (UPS)
OTE
can decrease or mitigate problems caused by power service fluctuations. Ver-
ify that the output of any power shaping device is compatible with the Alcatel
Wireless LAN Switch power supplies.
4Ste
Verify the power switch on the power supply is in the Off ( )
position.
C
AUTION
power switch is in the On (|) position. Verify the power switch is Off
( ) first.
5
Attach the power cord to the power supply.
Plug an appropriate power cord into the power input socket. The socket
accepts a power cord with a standard IEC320 plug.
C
AUTION
rated to 10 A and conform to grounded electrical standards in the
country where the product is operated.
N
—The 400 W power supply (OWA-6000-PS400) includes a power cord
OTE
retaining clip. When the power cord is attached, the clip can be used to hold
the cord in place and help prevent it from being pulled out accidentally (see
Figure 5-3
on
6
Attach the power cord to a proper electrical outlet.
C
AUTION
within easy reach of the operator and can be quickly disconnected if
necessary.
Repeat
Step 4
Once power is connected, you can perform the power-on test (see
12
Part 031639-00
—Never attach a power cord to a power supply while its
—For proper safety and performance, the power cord must be
page
32).
—For safety reasons, verify the power outlets and plugs are
through
Step 6
for each installed power supply.
page
15).
May 2005
Advertisement
Table of Contents
