C
HAPTER
Installing the Chassis
C
—Installation should be performed by a trained technician.
AUTION
This chapter covers the following installation topics:
Precautions to observe during installation
Requirements for Alcatel Wireless LAN Switch components
and rack mounting gear
Selecting a proper environment for the Alcatel Wireless LAN
Switch
Mounting the Alcatel Wireless LAN Switch in a rack
Connecting power to the Alcatel Wireless LAN Switch
Pre-Installation Checklist
You will need the following during installation:
OmniAccess 6000 Wireless LAN Switch components (see
"Minimum Switch Configuration"
OmniAccess 6000 rack mounting kit (see
on
Phillips or cross-head screwdriver.
19-inch equipment rack, or equivalent.
3U rack space with 10 cm (4 inches) clearance to the left,
right, front, and rear of the rack.
Another person to help position the switch.
Alcatel power cord for each power supply, rated to at least 10
A with IEC320 connector.
Adequate power supplies and electrical power (see
Management"
Cool, non-condensing air 0 to 40 ºC (32 to 104 ºF). May
require air conditioning.
Console terminal with RJ-45 or DB-9 serial port.
RS-232 serial cable with RJ-45 male connectors.
Alcatel serial adapter (included) if connecting to the console
with DB-9.
2
page
7).
on
page
on
page
7).
"Rack Mounting Kit"
27).
"Power
Installing the Chassis
5