Laser Notice - Alcatel-Lucent OMNIACCESS 6000 Installation Manual

Wireless lan switch
Hide thumbs Also See for OMNIACCESS 6000:
Table of Contents

Advertisement

OmniAccess 6000: Installation Guide
Warning—This is a Class A product. In a domestic environment, this product
may cause radio interference in which case the user may be required to take
adequate measures.
EU - Class A
This product complies with EN55022 Class A and EN55024 standards.
Safety
Lithium Battery Notice
The Alcatel 6000 Supervisor Card used with this product contains a lithium
battery.
C
—The lithium battery may explode if it is incorrectly replaced. Replace
AUTION
only with the same or equivalent type battery recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's
instructions.

Laser Notice

The Alcatel 6000 Line Cards used with this product use replaceable laser
transceiver modules on some ports.
CLASS 1
LASER PRODUCT
C
—Use of controls or adjustments of performance or procedures other
AUTION
than those specified in this manual may result in hazardous radiation exposure.
This product complies with 21 CFR Chapter 1, Subchapter J, Part 1040.10, and
IEC 60825-1: 1993, A1: 1997, A2: 2001, IEC 60825-2: 2000.
For continued compliance with the above laser safety standards, only
approved Class 1 modules from our approved vendors should be installed in
the product. See
modules and vendors.
iv
Part 031639-00
"Gigabit Ethernet Ports"
on
page 52
for a list of approved
May 2005

Advertisement

Table of Contents
loading

Table of Contents