Table of Contents
Advertisement
OmniAccess 6000: Installation Guide
Secure the power cord (optional 400 W
7
When the power cord is attached, swing the power cord retaining clip to the
right as shown in
from being removed accidentally.
8
Attach the power cord to a proper electrical outlet.
Verify that your site's electrical systems can handle the switch's power load.
Each standard power supply (OWA-6000-PS200) is rated at 200 W total
and is auto-ranging to accept 90-132/ 170-264 VAC, at 50 to 60 Hz.
Each optional power supply (OWA-6000-PS400) is rated at 400 W total and
is auto-ranging to accept 85 to 264 VAC, at 50 to 60 Hz.
Depending on the switch's total power load, you may be required to increase
the capacity of your site's electrical systems. See
page 29
for details.
N
—Use of a power line conditioner or Uninterruptable Power Supply (UPS)
OTE
can decrease or mitigate problems caused by power service fluctuations.
Verify that the output of any power shaping device is compatible with the
Alcatel Wireless LAN Switch power supplies.
C
AUTION
within easy reach of the operator and can be quickly disconnected if
necessary.
32
Part 031639-00
Figure
5-3. This will hold the plug in place and help prevent it
Right: Capture Cord
F
5-3 Using the Power Cord Retaining Clip
IGURE
—For safety reasons, verify the power outlets and plugs are
OWA-6000-PS400
Wrong: Around Plug Base
"Maximum Power Load"
only).
on
May 2005
Advertisement
Table of Contents
