Repacking The Scanner; Figure 9. Two People Placing The Scanner Onto The Skid - Bell and Howell Copiscan 8000 Plus Series Operator's Manual

5. Read Section 3.1, Recommended System Configuration Guidelines and Section 3.2,
Scanner Environment in this manual before you go any further with the scanner
setup.

4.1.1 Repacking the Scanner

If for any reason, you find you need to repack the scanner, carefully follow the
instructions below:
WARNING:
The scanner is heavy and should always be moved by two people.
CAUTION:
Do not lift the scanner by its feeder (in front). Lift it from beneath its sides.
1. Use the original shipping carton and packaging materials you saved from unpacking
the scanner.
2. If you don't have this carton, you may purchase one from Bell & Howell Imaging
Components. Refer to the Contact Information page at the front of this manual to
contact a Bell & Howell sales representative for reorder information.
3. With another person, grasp the scanner firmly underneath each side and lift it onto the
skid and into the shipping material.

Figure 9. Two People Placing the Scanner onto the Skid

4. Replace the scanner accessories and the cut-outs in the packaging inserts. Replace the
plastic shipping bag and the packaging inserts to the top of the scanner.
www.bellhowell.imagingcomponents.com
1-800-SCAN495
Copiscan 8000 Plus Series Operator Manual
16
August 25, 2000