Table of Contents
Advertisement
5.3.2.1 Determining Width, Length, and Thickness
The scanner can scan documents that fall within the range of specifications in the table
below:
Mode
Width
Minimum
ADF
2.6"
6.6 cm
Manual
2.6"
6.6 cm
Remove documents from the stack that fall outside these ranges.
NOTE:
You can tape documents that are smaller than the minimum width and length
requirements to a larger page side. The multifeed alarm may sound.
5.3.2.2 Preventing Document Jams and Multifeeds
Documents that contain tape, staples, or more than four pages can cause jams or
multifeeds.
Take the following steps to prevent jams and multifeeds from occurring.
1. Be sure that nothing sticky, such as the sticky side of tape, is exposed on the
document.
2. Be sure that no documents are taped together.
3. Remove any staples.
4. Remove any multiple part forms that contain more than four sheets of paper.
5.3.3 Setting Scanner Parameters
After you have removed tape, staples, and multiple part forms from the documents to be
scanned, you are ready to set the scanner parameters. This section serves as an
introduction to the processes for setting parameters. You may have to adjust scanner
parameters periodically.
You can set most scanner parameters using the procedures provided by the manufacturer
of your application software. Otherwise, you can set parameters using the scanner control
panel.
www.bellhowell.imagingcomponents.com
1-800-SCAN495
Copiscan 8000 Plus Series Operator Manual
Length
Maximum
Minimum
11.7"
2.6"
29.7 cm
6.6 cm
11.7"
4"
29.7 cm
10.2 cm
30
Thickness
Maximum
Minimum
17+"
.0018"
43 cm
.005 cm
17+"
.0018"
43 cm
.005 cm
Maximum
.0008"
.02 cm
.02"
.05 cm
August 25, 2000
Advertisement
Table of Contents
