Enabling And Disabling The Imprinter; Changing The Imprinter Printing Position - Bell and Howell Copiscan 8000 Plus Series Operator's Manual

NOTE:
Your host application software will override the settings that you have just made.
1. Insert a sample document into the feeder and initiate a scan.
2. Your imprint string should be on the document after it is scanned. Make sure that the
imprint string is in the appropriate location before beginning your scanning
application.
NOTE:
You may have to reset the index string to 000000 if you want to start indexing at 0.
3. You are now ready to endorse batches of documents.
5.4.2.10

Enabling and Disabling the Imprinter

The imprinter is always enabled when power is applied to the scanner. It becomes
operational when an ink cartridge is installed into the imprinter.
CAUTION:
Do not operate the scanner with the imprinter in the SERVICE position (the left most
position where it is protruding beyond the scanner's metal frame).
To disable the imprinter, remove the ink cartridge while in the SERVICE position and
slide the imprinter to one of the four other positions before closing the transport.
CAUTION:
Always remove the ink cartridge and slide the imprinter to one of the four endorsing
locations when not in use.
5.4.2.11

Changing the Imprinter Printing Position

The imprinter can be in four different locations left of center. Those positions include the
following:
• 1.38"
• 3.00"
• 4.25"
• 5.75"
To change the location of the imprinter, open the scanner by pulling the handle on the
right side of the scanner.
The position handle for the imprinter is just left of the handle used to open the scanner.
The imprinter position handle allows you to move the imprinter left to right into four
www.bellhowell.imagingcomponents.com
1-800-SCAN495
Copiscan 8000 Plus Series Operator Manual
53
August 25, 2000