Windows Clients Using Lantastic - Axis 570 User Manual

AXIS 570/670 User's Manual
Client-Server Printing:
Client Setup

Windows Clients using LANtastic

Note:
Follow these steps to use your AXIS 570/670 for client-server printing
at a Windows for Workgroups client:
1. In the Control Panel, select Printers.
2. Select a printer driver from the list of Installed Printers, or click
Add>> to install a new driver. Click Connect...
3. Select Network... in the Device Name list, select a local port
(LPT1 - LPT3) to redirect to your network printer.
4. In the Show Shared Printers on list, select the server from Server
Setup above.
5. In the Shared Printers list, select the printer you want to use.
6. Click OK, OK and Close.
7. Exit the Control Panel.
The client setup is completed and you can now print through your
AXIS 570/670.
From any Windows client, the AXIS 570/670 can also be used for
network printing in LANtastic environments.
LANtastic users can use the AXIS Utilities in exactly the same manner
as described in the preceding Windows sections, using a choice of Axis
utility software that is guided by the type of Windows client
employed:
• Refer to Using the AXIS Print Utility for Windows, on page 139, if
you are using a Windows for Workgroups client.
• Refer to Using the AXIS Print Monitor for Windows 95/98 and NT,
on page 124, if you are using a Windows 95, Windows 98 or
Windows NT client.
Make sure that your LANtastic client is running the desired
printing protocols.
Section 7: Setting Up - Windows
143