Axis 570 User Manual page 115

Section 5: Setting Up - IBM Mainframe
114
Configuring the
AXIS 570e/670e
Verifying the
communication
Follow the instructions below to configure your AXIS 570e/670e
using a standard Web browser:
1. Start a Web browser, e.g. Internet Explorer or Netscape Navigator.
2. Enter the IP address or the host name of the AXIS 570e/670e in
the location field and press the ENTER key on your keyboard.
The internal Web pages of the AXIS 570e/670e appear. You may
be asked to enter a user name and a password. The default values
are root and pass.
3. Click the Configuration button.
4. Select TCP/IP from the header.
5. The Reverse Telnet parameters PR1, PR2 and PR3 are by default
setup for IPDS data streams, emulating an IBM 4028 printer
model 1 on the port numbers 5001, 5002 and 5003 respectively.
If you need to change a port number, enter a new number in the
text field and click the Submit TCP/IP settings button.
Otherwise you do not have to do anything.
6. Select IBM IPDS Configuration settings from the header.
7. Select your preferred system language from the IPDS System
Language drop-down list.
8. Click the Submit IBM IPDS Configuration settings button.
9. Select IBM IPDS PRINTER DRIVER from the header.
10. Select the appropriate page properties and click the Submit IBM
IPDS PRINTER DRIVER settings button.
By sending a print job from the Mainframe to the AXIS 570e/670e,
you can verify that the setup procedures have been performed correctly
and that communication is established.
AXIS 570/670 User's Manual