Axis 570 User Manual page 68

AXIS 570/670 User's Manual
Configuring the
AS/400 Host System
Follow the instructions below to create a printer device description:
1. Issue the command CRTDEVPRT. A panel, similar to the
example on page 69, will be displayed.
2. Press F11 to display keywords.
3. Select a name for the printer device and enter it at the
Description (DEVD)
A-Z and the numerals 0-9, but must begin with a letter. A
maximum of 10 characters are allowed.
4. Enter at the
*LAN
5. Enter at the
3812
6. Enter at the
1 Device model (MODEL)
7. Enter at the
*IP
8. Enter a port number at the
default port numbers are defined in the table below:
Port
Number
5011
5012
5013
9. Enter a FGID number at the
Lists of all supported FGIDs are available in Appendix G - IPDS
Fonts, on page 239 and Appendix D - IBM Fonts, on page 225.
10. Enter
*AUTOCUT
11. The
Host print transform (TRANSFORM)
if the AS/400 will do EBCDIC-to-ASCII transformation of the
print data. Enter
*NO
12. Define the
Remote location (RMTLOCNAME)
address of the AXIS 570/670 or the host name you have specified
in the AS/400 TCP/IP host table.
Section 4: Setting Up - AS/400
line. The name may comprise the letters
Device class (DEVCLS)
Device type (TYPE)
LAN attachment (LANATTACH)
Port number (PORT)
Data Stream Logical Printer
SCS
SCS
SCS
Font Identifier (FONT)
at the
Form feed (FORMFEED)
, since this is done by the AXIS 570/670.
Device
line.
line.
line.
line.
line. The
Destination
PR4
PR5
PR6
line.
line.
entry specifies
. Use the IP
67