Pin Code Change Function - Ducati Diavel Owner's Manual

PIN CODE change function

E
This function changes your four number PIN CODE.
To access the function it is necessary to view the "setting"
menu page 48, using button (1, fig. 14) "▲" or (2, fig. 14)
"▼" select the "PIN CODE" function and press the reset
button (12, fig. 12) to go to next page.
Note
If "INSERT NEW PIN CODE" and the dashes "- - - -"
appear when accessing this function, this means that the
function was not active as the PIN CODE was never entered.
Enter your PIN as described in the previous paragraph "PIN
CODE activation function".
When accessing the function, "MODIFY PIN CODE", "OLD
PIN" with four dashes "- - - -" in the bottom line will appear
on the display highlighted in green; now enter the 4 digit
code.
Note
To change the PIN, you must know the currently stored
PIN.
Now you shall enter the "old" PIN code (OLD PIN).
Press the reset button (12, fig. 12); each time you press the
button (2, fig. 14) "▼" the displayed number increases from
"0" to "9" and then returns to "0";
to confirm the number, press the reset button (12, fig. 12);
repeat the procedure until inserting the fourth digit;
Press the reset button (12, fig. 12) again to confirm.
If the entered code is incorrect, the dashboard will return to
the four dashes " - - - - " in order to enter the code again.
94
If the entered code is correct, "CORRECT" is automatically
highlighted in green for about 2 seconds and then the four
dashes " - - - - " next to "NEW PIN" indication are
automatically highlighted; now enter the "new" 4 digit code.
Press the reset button (12, fig. 12); each time you press the
button (2, fig. 14) "▼" the displayed number increases from
"0" to "9" and then returns to "0";
to confirm the number, press the reset button (12, fig. 12);
repeat the procedure until inserting the fourth digit;
Press the reset button (12, fig. 12) again to confirm.
Item "MEMORY" is automatically highlighted.
To store the entered new PIN, press the reset button (12, fig.
12) for 3 seconds with "MEMORY" indication highlighted in
green.
As a confirmation of the new PIN storage, the display will show
message "MEMORIZED" for about 2 seconds and then
"EXIT" is automatically highlighted.
To exit the setting function, press the reset button (12, fig.
12) when "EXIT" is highlighted.
Note
There is no limit to the amount of times you can
change your PIN CODE.