Setting The 3D Y/C Separation - Denon AVC-A1XV Operating Instructions Manual

5
(Main unit) (Remote control unit)
NOTES:
• When the component video input signal is a resolution other than 480i/576i, this setting is invalid and the input video is output without
change.
• The setting of the aspect ratio is valid when the resolution has been set to 1080i or 720p. When the video is output at another resolution,
please set the aspect ratio at the TV side.
• If the video input signal includes copyright protection data, the signal is output with a resolution of 480p or 576p, even if the resolution
is set to 1080i or 720p.

4-4. Setting the 3D Y/C Separation

• This setting sets the action detection sensitivity of the 3-dimensional Y/C separation at the time of the video signal up-conversion to S-Video.
1
(Main unit) (Remote control unit)
2
(Main unit) (Remote control unit)
3
(Main unit) (Remote control unit)
4
(Main unit) (Remote control unit)
Enter the setting.
The Video Setup menu reappears.
CH SEL
ENTER
Select "3D Y/C Separation" at the Video Setup
menu.
CH SEL
ENTER
Display the 3D Y/C Separation screen.
CH SEL
ENTER
Select the setting.
HIGH : This sets the action detection sensitivity to a high level. It suits video with fast action.
MID : This is the standard setting. Usually, this setting is recommended.
CH SEL
ENTER
LOW : This sets the action detection sensitivity to a low level. It suits video with little action,
such as still images, etc.
Enter the setting.
The Video Setup menu reappears.
CH SEL
ENTER
* V i d e o S e t u p
3 D Y / C S e p .
* 3 D Y / C S e p .
M o t i o n D e t : M I D
69