Learning Function - Denon AVC-A1XV Operating Instructions Manual

Learning function

If an AV component is not a DENON product, or if it cannot be operated via codes provided in the AVC-A1XV remote control's internal preset
memory, or if its codes cannot be successfully learned by the AVC-A1XV remote control, then you should use the remote control that was supplied
with that AV component to operate the component.
1 Press the power ON button and the OFF button
simultaneously.
Press the "2" button to select
2
Learning setup.
3 Press the Mode button for the component you want to
learned, then press the ENTER button.
Learning is not possible for the AMP, ZONE2, ZONE3 and
ZONE4 modes.
4 Buttons that allow learning will light. Press the button that you
wish to be learned.
enter the learning standby mode.
• To cancel, press the power ON button
and the OFF button simultaneously.
5 Point the Remote control units directly at each other and
press and hold in the button on the other Remote control unit
which you want to "learn".
114
CH SEL
ENTER
The display will go off and the unit will
Other remote
control unit
3, 7
2
3
6 "OK" appears on the Remote control unit's display and
learning is completed.
• Other keys can be "learned" by repeating steps 5 to 6.
• "FAIL" appears on the Remote control unit's display,
repeating steps 4 to 6.
7 The mode can be switched by
pressing a mode selector button.
The "Buttons that allow learning"
display reappears and the learning
standby mode is set.
8 To cancel the learning mode, press the power ON button and
the OFF button simultaneously again.
1, 8
6
RC-995