Denon AVC-A1XV Operating Instructions Manual page 138

q Select the various surround parameters.
5
(Main unit)
Example: DOLBY PL
When set with the on-screen display using the Remote control
unit while in the MUSIC mode, set the "
0" using the Cursor up and down buttons, then press the
Cursor left button.
Press the ENTER button to return to the previous screen.
6
or
(Main unit)
NOTE:
• There are four Dolby Surround Pro Logic modes (NORMAL, PHANTOM, WIDE and 3 STEREO). The AVC-A1XV sets the mode
automatically according to the types of speakers set during the system setup process (pages 46, 47).
Surround parameters r
Pro Logic II x and Pro Logic
• Select one of the modes ("Cinema", "Music", "Pro Logic"or "Game").
• The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround.
• The Music mode is recommended for stereo music and surround-encoded stereo music sources.
• The Pro Logic mode emulates Dolby Laboratories' original Dolby Pro Logic surround decoding, and may provide better results with older,
legacy surround-encoded program material.
• The Game mode is optimized for computer and/or dedicated game box consoles, that feature stereo analog or digital outputs. It can only
be used with 2-channel stereo sources.
Panorama Control:
This mode extends the front stereo image to include the surround speakers for an exciting "wraparound" effect with side wall imaging.
Select "OFF" or "ON".
Dimension Control:
This control gradually adjust the soundfield either towards the front or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only from the center speaker; only from the left/right speakers as a phantom image;
or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
138
CH SEL
ENTER
(Remote control unit)
II
x music mode screen.
" mark to "OPTION
CH SEL
ENTER
(Remote control unit)
II Mode:
w Adjust the parameters setting.
• DEFAULT setting
Select "Default Yes 0", then parameters set to default setting.
Press the ENTER or SURROUND PARAMETER button
to complete the setting.
or
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
(Main unit) (Remote control unit)