Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Denon Manuals
  4. Receiver
  5. AVR-5805
  6. Supplementary manual

Denon AVR-5805 Supplementary Manual

Avr/avc control protocol
Hide thumbs Also See for AVR-5805:

Advertisement

Quick Links

Download this manual See also: Operating Manual, User Manual
DENON AVR/AVC control protocol
Application model :
Application terminal : RS-232C/ Ethernet
Connector specification
1. RS-232C
Connector type : DB-9pin female type, slave straight connection (DCE type)
( 1pin : GND , 2pin : TxD , 3pin : RxD , 5pin : Common(GND) , 4,6,7,8,9pin : NC )
Communication format :
Synchronous system
Communication system
Communication speed
Character length
Parity control
Start bit
Stop bit
Communication procedure
Communication data length
AVR-5805/AVC-A1XV
: Tone step synchronization
: A half duplex
: 9600bps
: 135 bytes (maximum)
: 8 bits
: None
: 1 bit
: 1 bit
: Non procedural
1/25
29.Mar.06
Ver. 4.37a

Advertisement

loading

Related Manuals for Denon AVR-5805

Summary of Contents for Denon AVR-5805

  • Page 1 DENON AVR/AVC control protocol Application model : AVR-5805/AVC-A1XV Application terminal : RS-232C/ Ethernet Connector specification 1. RS-232C Connector type : DB-9pin female type, slave straight connection (DCE type) ( 1pin : GND , 2pin : TxD , 3pin : RxD , 5pin : Common(GND) , 4,6,7,8,9pin : NC )
  • Page 2 2. Ethernet ： RJ-45(10BASE-T/100BASE-TX) Connector type Example ① Example ② Communication format ： Communication system Communication speed Communication port Communication data length Ethernet Cross cable Ethernet Ethernet Straight Straight cable cable : A half duplex : 10Mbps/100Mbps : TCP port 23 (telnet) : 135bytes (maximum) 2/25 AVR/AVC...
  • Page 3 <Network Option:Standby Mode Power Saving> “OFF”---Use this setting when using the AVR-5805/AVC-A1XV connected in a network. “ON”--- Use this setting when not using the AVR-5805/AVC-A1XV connected in a network. This setting is reducing the power consumption in the standby mode.
  • Page 4 Protocol specification The following three data forms is defined. COMMAND The message sent to a system(AVR/AVC) from a controller(Touch Panel etc.) A command to a system is given from a controller. EVENT The message sent to a controller(Touch Panel etc.) from a system(AVR/AVC) The result is sent, when a system is operated directly and a state changes.
  • Page 5 29.Mar.06 The example of a command * <CR> is the meaning of 0x0D. SIDVD<CR> : Select Input source DVD MSTHX SURROUND EX<CR> : surround Mode Set to THX SURROUND EX MVUP<CR> : Master Volume UP PWON<CR> : system PoWer ON PWSTANDBY<CR>...
  • Page 6 Others A) COMMAND is receivable also during transmission of EVENT. B) Since CHANNEL VOLUME changes simultaneously when the SURROUND MODE changes, the value of the channel volume of all channels returns as EVENT. C) CHANNEL VOLUME returns the data of ALL channels by the present SURROUND MODE also including an intact channel. In this case, the data of an intact channel is set to "50".
  • Page 7 COMMAND and PARAMETER list COMMAND PARAMETER STANDBY DOWN FL UP FL DOWN FL ** FR UP FR DOWN FR ** C UP C DOWN C ** SW1 UP SW1 DOWN SW1 ** SW2 UP SW2 DOWN SW2 ** LFE UP LFE DOWN LFE ** SLA UP...
  • Page 8 COMMAND PARAMETER SLB UP SLB DOWN SLB ** SRB UP SRB DOWN SRB ** SBL UP SBL DOWN SBL ** SBR UP SBR DOWN SBR ** SB UP SB DOWN SB ** EXLA UP EXLA DOWN EXLA ** EXRA UP EXRA DOWN EXRA ** EXLB UP...
  • Page 9 COMMAND PARAMETER EXLC UP EXLC DOWN EXLC ** EXRC UP EXRC DOWN EXRC ** PHONO TUNER VCR-1 VCR-2 VCR-3 VCR-4 V.AUX CDR/TAPE VCR-1 VCR-2 VCR-3 VCR-4 V.AUX SOURCE CV COMMAND : "*" parameter uses two or three ASCII characters. (see page4 J) section) The BOLD COMMANDS are new.
  • Page 10 The BOLD COMMANDS are new. function set DIGITAL INPUT AUTO mode set DIGITAL INPUT force PCM mode set DIGITAL INPUT force DTS mode ---Invalid at AVR-5805 set force ANALOG INPUT mode set EXT.IN-1 or EXT.IN mode set EXT.IN-2 mode SURROUND mode set ---This is received as "SATNDARD".
  • Page 11 COMMAND PARAMETER 5CH STEREO 7CH STEREO 9CH STEREO SUPER STADIUM ROCK ARENA JAZZ CLUB CLASSIC CONCERT MONO MOVIE MATRIX VIDEO GAME MPEG2 AAC AAC+DOLBY EX USER1 USER2 USER3 TONE DEFEAT ON TONE DEFEAT OFF SB:MTRX ON SB:NON MTRX SB:PL2xCINEMA SB:PL2xMUSIC SB:OFF CINEMA EQ.ON CINEMA EQ.OFF...
  • Page 12 COMMAND PARAMETER ROOM EQ:AUDYSSEY ROOM EQ:FRONT ROOM EQ:FLAT ROOM EQ:MANUAL ROOM EQ:OFF DELAY UP DELAY DOWN DELAY *** DOWN ****** (6 digits) --- ****.** kHz at AM band (>050000 is AM.) DOWN **(PRESET No.) AUTO MANUAL TF, TP, TM COMMAND : '*' parameters can NOT operate when INPUT source isn’t TUNER. The BOLD COMMANDS are new.
  • Page 13 COMMAND PARAMETER Z2CV Z2FL UP MULTI ZONE-2 CHANNEL VOLUME UP/DOWN , FL DOWN ---FRONT Lch FL ** **:38 to 62 by ASCII , 50=0dB FR UP FR DOWN ---FRONT Rch FR ** **:38 to 62 by ASCII , 50=0dB C UP C DOWN ---CENTERch C **...
  • Page 14 COMMAND PARAMETER PHONO MULTI ZONE-2 mode set , and select source ---The name of PARAMETER is CDR/TAPE SOURCE MULTI ZONE-2 mode cancel MULTI ZONE-2 VOLUME UP/DOWN , direct change to ***dB DOWN **:00 to 99 by ASCII , 80=0dB, 99=---(MIN) MULTI ZONE-2 ON/OFF change Z2MU ZONE2 OUTPUT MUTE ON/OFF change...
  • Page 15 COMMAND PARAMETER Z2MS STEREO SURROUND mode set DOLBY PRO LOGIC DOLBY PL2 DOLBY PL2x DOLBY DIGITAL DOLBY D EX DTS NEO:6 DTS SURROUND DTS ES DSCRT6.1 DTS ES MTRX6.1 WIDE SCREEN 5CH STEREO 7CH STEREO SUPER STADIUM ROCK ARENA JAZZ CLUB CLASSIC CONCERT MONO MOVIE MATRIX...
  • Page 16 COMMAND PARAMETER Z2PS TONE DEFEAT ON PARAMETER setting TONE DEFEAT OFF SB:MTRX ON SURROUND BACK SP MODE set SB:NON MTRX ---MTRX ON = SURR.EX ON = DSCRT ON SB:PL2xCINEMA SB:PL2xMUSIC SB:OFF CINEMA EQ.ON CINEMA EQ.OFF MODE : MUSIC MODE : CINEMA MODE : GAME MODE : PRO LOGIC DELAY UP...
  • Page 17 COMMAND PARAMETER PHONO MULTI ZONE-3 mode set , and select source ---The name of PARAMETER is CDR/TAPE SOURCE MULTI ZONE-3 mode cancel MULTI ZONE-3 VOLUME UP/DOWN , direct change to ***dB DOWN **:00 to 99 by ASCII , 80=0dB, 99=---(MIN) MULTI ZONE-3 ON/OFF change Z3MU ZONE3 OUTPUT MUTE ON/OFF change...
  • Page 18 EVENT(or RESPONSE) and PARAMETER list EVENT PARAMETER STANDBY FL ** FR ** C ** SW1 ** SW2 ** LFE ** SLA ** SRA ** SLB ** SRB ** SBL ** SBR ** SB ** EXLA ** EXRA ** EXLB ** EXRB ** EXLC ** EXRC **...
  • Page 19 EVENT PARAMETER OUTPUT MUTE ON/OFF change PHONO INPUT source change TUNER VCR-1 VCR-2 VCR-3 VCR-4 V.AUX CDR/TAPE VIDEO INPUT source change VCR-1 VCR-2 VCR-3 VCR-4 V.AUX SOURCE VIDEO SELECT mode cancel The BOLD COMMANDS are new. function MUON<CR> MUOFF<CR> SIPHONO<CR> SICD<CR>...
  • Page 20 EVENT PARAMETER DIRECT SURROUND mode change PURE DIRECT STEREO MULTI CH IN MULTI CH IN +PL2x CINEMA MULTI CH IN +PL2x MUSIC MULTI CH DIRECT MULTI CH DIRECT +PL2x CINEMA MULTI CH DIRECT +PL2x MUSIC MULTI CH PURE D MULTI CH PURE D +PL2x CINEMA MULTI CH PURE D +PL2x MUSIC...
  • Page 21 EVENT PARAMETER DTS ES DSCRT6.1 DTS ES MTRX6.1 DTS+PL2x CINEMA DTS+PL2x MUSIC DOLBY H/P DTS+DOLBY H/P PL2x C+THX PL2 C+THX PL+THX NEO:6 C+THX THX5.1 THX U2 CINEMA THX MUSIC MODE THX GAMES MODE THX6.1 THX SURROUND EX WIDE SCREEN 5CH STEREO 7CH STEREO 9CH STEREO SUPER STADIUM...
  • Page 22 EVENT PARAMETER USER1 USER2 USER3 ROOM EQ:AUDYSSEY ROOM EQ:FRONT ROOM EQ:FLAT ROOM EQ:MANUAL ROOM EQ:OFF DELAY UP AUDIO DELAY change, ***:000 to 999 by ASCII DELAY DOWN ---AVR5805：200=200ms（MAX） DELAY *** ****** (6 digits) TUNER Frequency change --- ****.** kHz at AM band **(PRESET No.) TUNER PRESET change to No.** TUNER BAND , MODE change...
  • Page 23 EVENT PARAMETER Z2CV FL ** MULTI ZONE-2 CHANNEL VOLUME change , FR ** C ** SW ** SL ** SR ** SBL ** SBR ** SB ** PHONO MULTI ZONE-2 source change ---The name of PARAMETER is CDR/TAPE SOURCE MULTI ZONE-2 mode cancel MULTI ZONE-2 VOLUME change , **:00 to 99 by ASCII MULTI ZONE-2 ON/OFF change Z2MU...
  • Page 24 EVENT PARAMETER Z2SV V.AUX SOURCE ZONE2 VIDEO SELECT mode cancel Z2MS STEREO ZONE2 SURROUND mode change DOLBY PRO LOGIC DOLBY PL2 CINEMA DOLBY PL2 MUSIC DOLBY PL2 GAME DOLBY PL2x CINEMA DOLBY PL2x MUSIC DOLBY PL2x GAME DOLBY DIGITAL DOLBY D EX DTS NEO:6 DTS SURROUND DTS ES DSCRT6.1...
  • Page 25 EVENT PARAMETER Z2PS DELAY UP AUDIO DELAY change, ***:000 to 999 by ASCII DELAY DOWN ---AVR5805：200=200ms（MAX） DELAY *** PHONO MULTI ZONE-3 source change ---The name of PARAMETER is CDR/TAPE SOURCE MULTI ZONE-3 mode cancel MULTI ZONE-3 VOLUME change , **:00 to 99 by ASCII MULTI ZONE-3 ON/OFF change Z3MU ZONE3 OUTPUT MUTE ON/OFF change...

This manual is also suitable for:

Avr-5805mk2 - av receiverAvc-a1xv