Multi Zone; Multi-Zone Playback With Multi-Source - Denon AVC-A1XV Operating Instructions Manual

y
Surround parameters
EFFECT:
This parameter turns the effect signals with multi surround mode speaker effects on and off in the WIDE SCREEN mode. When this
parameter is turned off, the SBL and SBR channel signals are equivalent to the SL and SR channels, respectively.
LEVEL:
This parameter sets the strength of the effect signals in the WIDE SCREEN mode. It can be set in 15 steps, from "1" to "15". Set this to
a low level if the positioning or phase of the surround signals sounds unnatural.
SB CH OUT:
"ON" ..................Playback is conducted using the surround back speaker.
"OFF".................Playback is conducted without using the surround back speaker.
NOTE: This operation can be performed directly using the SURROUND BACK button on the Main unit's panel.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: "small", "med.s" (medium-small), "medium", "med.l" (medium-large) and "large". "small" recreates a small sound
field, "large" a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 300 ms.
SW ATT:
This parameter for reducing the level of the subwoofer channel when playing in the EXT. IN input mode has been added. Depending on the
player you are using, the dubwoofer channel's playback level may seem too high. If so, set "SW ATT" to "ON".
For Denon players, use with the default settings.
Subwoofer ON/OFF:
The subwoofer output can be controlled directly.

12 MULTI ZONE

Multi-zone playback with multi-source

MULTI ZONE MUSIC ENTERTAINMENT SYSTEM
• When the outputs of the "ZONE2 (ZONE3, ZONE4)" OUT terminals are wired and connected to power amplifiers installed in other rooms,
different sources can be played in rooms other than the MAIN ZONE in which this unit and the playback devices are installed. (Refer to ZONE2
(ZONE3, ZONE4) on the diagram below.)
• Settings can be made at "7-2. Power Amp Assign" in the System Setup Menu so that the same source as the ZONE2 (ZONE3, ZONE4) pre-
out terminals can be played from the speakers connected to the ZONE2 (ZONE3, ZONE4) speaker terminals. (See pages 96~100)
To control playback devices other than the ones above, either use that device's Remote control unit or preset a separately sold programmable
Remote control unit.
NOTES:
• For the AUDIO output, use high quality pin-plug cords and wire in such a way that there is no humming or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices' operating instructions.
• Video signals are output from the ZONE3 video output terminals even when the power of ZONE3 is turned off.
146