Calibrate Touch Screen; Network Setup - Xerox 6279 User Manual

3. Select the Administration tab.
4. Select Control Panel.
The Control Panel screen displays.
5. Select Set scan start mode....
The Set Scan Start Mode screen displays.
6. Select the Automatic or Use Start key radio button.
• Automatic: Scanning starts automatically after an original is inserted into the
Scanner and prefeeds.
• Use Start key: You must press the Start button to initiate scanning after the
document prefeeds.
7. Select Save.
8. Select Close on the Control Panel screen to return to the Machine Info screen.
9. Select the Services button on the Control Panel and Copy if you intend to scan a
document at this time.
NOTE
Once this feature is enabled, users selecting options from the Services menu will
get a "press start" message.

Calibrate Touch Screen

Your User Interface Touch Screen is calibrated when it is installed. Calibration aligns the
cursor to the place on the screen that you touch. The user interface does not typically
need to be recalibrated, unless it is not working correctly or you reinstall the controller.
1. Press the Services button on the Control Panel.
The Services menu screen displays.
2. Select Machine Info from the Services menu screen.
The Machine Info screen displays.
3. Select the Administration tab.
4. Select Control Panel.
5. Select Calibrate Touch Screen.
6. Press and hold your finger on the calibration symbol in each corner of the screen until
it moves to the next corner. It will touch all four corners.
7. Once the symbol moves to all four corners, the user interface prompts you to touch
anywhere on the screen to save the calibration data.
8. The User Interface saves the calibration data and displays the Control Panel screen.

Network Setup

Prior to being able to communicate with your FreeFlow Accxes scanner and printer, the
FreeFlow Accxes controller needs to be configured to the network.
® ®
Xerox 6279 Wide Format Solution
Copy/Scan User Guide
System Administration
5-19