Xerox 6279 User Manual page 51

5. Evenly and gently insert the lead edge of the document into the Scanner Feed-in
Shelf.
• If the document does not feed automatically, the Scan Start mode may be set
to Manual Start. In this case, press the Start button. For more information about
the Scan Start mode, refer Chapter 5, System Administration,
• A document jam may occur if you pull or press down too hard on an original while
it scans.
• To prevent document jams when copying originals that contain holes, orient the
original so that the holes are feed in last (trail edge)
• Hold the original down flat with two hands (one on either side of it) while it feeds
into the starting position. Doing this helps prevent wrinkles that can cause dark
areas on the copy.
• Keep guiding the original until it feeds automatically.
For more information about this feature, refer to the section in Chapter 5 System
Administration of this manual.
NOTE
When the Scanner detects the original, it will feed it a short distance and stop
briefly, you can then feed the cut sheet media into the machine and the copy
will be made automatically.
6. If the scanner is equipped with the Front Return Guides, the original will exit toward
the front of the machine. You may wish to guide the lead edge of the original as it
travels toward you.
NOTE
Remove the Front Return Guides guides before copying an original that may
not flex and flow easily along them. This will prevent the guides from falling off
of the machine and getting damaged.
® ®
Xerox 6279 Wide Format Solution
Copy/Scan User Guide
Copying and Printing Documents
Set Start Scan Mode.
2-7