Intel® Server Board S2600CO Family TPS
Figure 13. Intel
The following are generic DIMM population requirements that generally apply to the Intel
Server Board S2600CO.
All DIMMs must be DDR3 DIMMs
Unbuffered DIMMs can be ECC or non-ECC. However, Intel
supports ECC memory for its server products.
Mixing of Registered and Unbuffered DIMMs is not allowed per platform.
Mixing of LRDIMM with any other DIMM type is not allowed per platform.
Mixing of DDR3 voltages is not validated within a socket or across sockets by Intel
1.35V (DDR3L) and 1.50V (DDR3) DIMMs are mixed, the DIMMs will run at 1.50V.
Mixing of DDR3 operating frequencies is not validated within a socket or across sockets
®
by Intel
. If DIMMs with different frequencies are mixed, all DIMMs will run at the
common lowest frequency.
Quad rank RDIMMs are supported but not validated by Intel
A maximum of 8 logical ranks (ranks seen by the host) per channel is allowed.
Mixing of ECC and non-ECC DIMMs is not allowed per platform.
DIMMs with different timing parameters can be installed on different slots within the
same channel, but only timings that support the slowest DIMM will be applied to all. As a
Revision 1.4
®
Server Board S2600CO DIMM Slot Layout
Intel order number G42278-004
Functional Architecture Overview
®
only validates and
®
.
®
®
. If
25