Initial Settings; Adjusting Initial Settings; Setting The Fm Tuning Step; Switching Auto Pi Seek - Pioneer DVH-P5000MP Operation Manual

Initial Settings

Adjusting initial settings

1
Initial settings lets you perform initial set up of
different settings for this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press F and hold until function name
appears in the display.
3 Press F to select one of the initial set-
tings.
Press F repeatedly to switch between the fol-
lowing settings:
FM (FM tuning step)A-PI (auto PI seek)
WARN (warning tone)AUX (auxiliary set-
ting)DIMMR (dimmer)R-SP (rear output
and subwoofer controller)TEL (telephone
muting/attenuation)A-PLY (auto play)
D_ATT (digital attenuation)
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down F until the unit turns off.
# When the multi-channel processor (e.g., DEQ-
P7000) is connected to this unit, you can operate
D_ATT instead of R-SP.

Setting the FM tuning step

Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
All manuals and user guides at all-guides.com
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Press F to select FM.
Press F repeatedly until FM appears in the dis-
play.
2 Press m or n to select the FM tuning
step.
Pressing m or n will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
Note
The tuning step remains at 50 kHz during manual
tuning.

Switching Auto PI Seek

The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Press F to select A-PI.
Press F repeatedly until A-PI appears in the
display.
2 Press r to turn Auto PI seek on.
A-PI :ON appears in the display.
# To turn Auto PI seek off, press q.

Switching the warning tone

If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press F to select WARN.
Press F repeatedly until WARN appears in the
display.
Section
15
77
En