Recording With The Front Panel - JVC BD-X201M Instructions Manual

Recording

Recording with the Front Panel

This DVD recorder recording operations can be carried out in two different ways — namely, using the buttons provided on the front
panel and using the on-screen REC CONTROL panel. In the latter case, furthermore, recording operations can be performed using
a keyboard. The following section, however, will provide a description of recording using the front panel buttons.
On a DVD, the section of video recorded between the start of recording and pressing of the STOP button to end recording is stored
as a single title, and a unique title number is assigned to each of these sections. A single disc can contain up to 99 different titles.
In addition, each title can be separated into a number of different chapters by inserting chapter marks at the appropriate points, and
each title can contain up to 99 chapters.
Information relating to titles and chapters is stored on a disc in the form of title and chapter menus. When the disc is being played,
therefore, the title and chapter menus can be used to access specific sections of stored video and audio.
Monitor display
04/05/04
CHAPTER 01 0:11:22
11:20:00
Title and chapter numbers
Notes
● A maximum of 10 minutes will be
required to complete title closing.
● The remaining time available for
recording on a disc will be displayed
on the monitor. Note that this is to be
used as a general guide, not as an
exact figure. (DISPLAY and REMAIN
from the DISPLAY MENU screen must
both be ON for this figure to be
displayed.)
● During the recording process, the
current title number and chapter
number are displayed on the monitor.
(ONSCREEN will be displayed when
the DISPLAY item is ON and the TITLE/
CHAPTER/INDEX item is set to
TITLE+CHAPTER.)
38
OPERATE
AUDIO
CH1
DOLBY DIGITAL
LPCM MPEG
CH2
PHONES REV STOP
STOP button
Remaining time Insert a disc that can be recorded on.
1.
With the DVD recorder stopped, make all of the required settings
and adjust the audio recording levels.
000 min
2.
Start recording.
This is done by pressing the REC and PLAY buttons simultaneously.
3.
Pause recording.
This is done by pressing the PAUSE button.
● The recording pause mode is entered.
REC
TITLE 01 0:11:22
4.
Restart recording.
Press the PLAY or PAUSE button.
● Recording will begin once again and a new chapter will be created in the
5.
End recording (i.e., close the title)
Press the STOP button when either recording or paused.
● The action of the DVD recorder following the end of recording depends on
If additional recording is to be carried out, repeat steps 1 through
5 above.
● In such a case, the subsequent recording is stored as a new title.
LCD display
TITLE CHAPTER
PLAY FWD PAUSE REC TOP
MENU
REC button
PAUSE button
When the AUTO CHAPTER (REC PAUSE) item of the RECORDER [1/2]
screen is set to ON, a chapter mark is automatically inserted when the
recording pause mode is entered.
A number of different methods can also be used for the manual or automatic
insertion of chapter marks. ( Page 39)
current title.
the setting of EDIT MENU from the DVD MENU screen.
DISABLE : Recording is ended and the chapter menu is created using
preset settings (i.e., the title is closed).
ENABLE : The THUMBNAIL EDIT screen will appear. This screen can be
used to modify the chapter menu's display style, to change the
thumbnails used, to input chapter names, and to perform other
similar functions. For more details, refer to page 44.
BUSY
OPEN/CLOSE
OPEN/CLOSE button
OPTION DV Y/C LINE
SET UP
SET
MENU