Recording With The Front Panel - JVC BD-X200E Instructions Manual

Recording with the Front Panel

BD-X200 recording operations can be carried out in two different ways — namely, using the buttons provided on the front panel and
using the on-screen REC CONTROL panel. In the latter case, furthermore, recording operations can be performed using a keyboard
and mouse. The following section, however, will provide a description of recording using the front panel buttons.
On a DVD, the section of video recorded between the start of recording and pressing of the STOP button to end recording is stored
as a single title, and a unique title number is assigned to each of these sections. A single disc can contain up to 99 different titles.
In addition, each title can be separated into a number of different chapters by inserting chapter marks at the appropriate points, and
each title can contain up to 99 chapters.
Information relating to titles and chapters is stored on a disc in the form of title and chapter menus. When the disc is being played,
therefore, the title and chapter menus can be used to access specific sections of stored video and audio.
Monitor display
TITLE 1 0:11:22
04/05/04
11:20:00 CHAPTER 1 0:11:22
Title and chapter numbers
Notes
A maximum of 10 minutes will be
required to complete title closing.
The remaining time available for
recording on a disc will be displayed
on the monitor. Note that this is to be
used as a general guide, not as an
exact figure. (DISPLAY and REMAIN
from the DISPLAY MENU screen must
both be ON for this figure to be
displayed.)
During the recording process, the
current title number and chapter
number are displayed on the monitor.
(DISPLAY and TITLE/CHAPTER from
the DISPLAY MENU screen must both
be ON for these numbers to be
displayed.)
OPERATE
DVD RECORDER BD-X200
AUDIO
TITLE
CH1
DOLBY DIGITAL
LPCM MPEG
CH2
STOP PLAY
PHONES REV
STOP button
Remaining time Insert a disc that can be recorded on.
1.
With the DVD recorder stopped, make all of the required settings
and adjust the audio recording levels.
000 min
2.
Start recording.
This is done by pressing the REC and PLAY buttons simultaneously.
3.
Pause recording.
This is done by pressing the PAUSE button.
The DVD recorder will adopt Recording Pause mode and a chapter mark will
REC
be inserted at the current position.
A number of different methods can also be used for the manual or automatic
insertion of chapter marks. (☞ Page 40)
4.
Restart recording.
Press the PLAY or PAUSE button.
Recording will begin once again and a new chapter will be created in the
current title.
5.
End recording (i.e., close the title)
Press the STOP button when either recording or paused.
The action of the DVD recorder following the end of recording depends on
the setting of EDIT MENU from the SYSTEM MENU screen.
DISABLE : Recording is ended and the chapter menu is created using
ENABLE : The THUMBNAIL EDIT screen will appear. This screen can be
If additional recording is to be carried out, repeat steps 1 through
5 above.
In such a case, the subsequent recording is stored as a new title.
LCD display
OPEN/CLOSE
OPTION DV Y/C LINE
CHAPTER
SET
FWD PAUSE REC TOP
MENU MENU
REC button
PAUSE button
preset settings (i.e., the title is closed).
used to modify the chapter menu's display style, to change the
thumbnails used, to input chapter names, and to perform other
similar functions. For more details, refer to page 47.
BUSY
OPEN/CLOSE button
SET UP
E-39