Jura IMPRESSA S9 One Touch Manual page 57

E If you want to descale the machine at a later point in time, turn
the Rotary Switch until
maintenance programme by pressing the Rotary Switch. The
prompt 'Decalcify machine' remains on the display.
c T Press the maintenance button.
EMPTY TRAY
T Empty the drip tray and coffee grounds container and put
them back into the machine.
SOLVENT IN TANK
T Remove the water tank and empty it.
T Completely dissolve the contents of one blister (3 JURA des-
caling tablets) in a container that holds 600 ml of water. This
may take several minutes.
T Pour the solution into the empty water tank and insert it in
the machine.
SOLVENT IN TANK
nance button c lights up.
T Remove the frother from the Connector System
T Place a receptacle under the hot water spout and another
under the Connector System
c T Press the maintenance button.
, water flows out of the Connector System
DECALCS
the hot water spout. The maintenance button c flashes
during the descaling operation.
E You can follow the current status of descaling on the progress
bar.
The process is interrupted,
T Empty the receptacles below the hot water spout and the
Connector System
T Empty the drip tray and coffee grounds container and put
them back into the machine.
RINSE WATER TANK
T Remove the water tank and rinse it thoroughly.
T Fill the water tank with fresh, cold water and reinsert.
PRESS RINSE
is displayed. Exit the
START NO
/
PRESS RINSE
.
©
EMPTY TRAY
.
©
/
FILL WATER TANK
, the maintenance button c lights up.
6 Maintenance
, the mainte-
.
©
and
©
.
57