Set Mode; Selecting Set Mode; Set Mode Items - Icom IC-746 Instruction Manual

10

SET MODE

10-1 Selecting set mode

Set mode is used for programming infrequently
changed values or conditions of functions.
Push [MENU] to select
Push [F5] to enter set mode.
Push [F1] or [F2] to change the selected item.
• Push and hold [F1] or [F2] to cycle through the available

set mode items.

Rotate the tuning dial to set the desired condition for
a selected item.
Push [MENU] 2 times to exit set mode and select
.
10-2 Set mode items
1.
This item sets the audio level for confirmation beep
tones. The level is selectable from 0% to 100% in 1%
steps. When beep tones (item 7) are turned OFF, this
setting has no effect.
2.
This item allows you to set a maximum volume level
for confirmation beep tones. Confirmation beep tones
are linked to the [AF] control until a specified volume
level is reached—further rotation of the [AF] control
will not increase the volume of the beep tones.
3.
This item is used for a simple frequency check of the
transceiver. See p. 65 for calibration procedures.
NOTE: Turn the calibration marker OFF after
checking the frequency of the transceiver.
4.
When an optional filter is installed in the 9 MHz filter
socket (1), this selection is necessary, otherwise the
filter cannot be selected.
FL-103, FL223, FL-100, FL-232 or FL-101 can be se-
lected. See p. 42 for details.
60
, if necessary.
[MENU]
F1 F2 F3
Push [F-5] to select set mode.
Tuning dial
F4 F5