Programmed Scan And Fine Programmed Scan - Icom IC-746 Instruction Manual

8
SCAN OPERATION
8-2 Programmed scan and fine programmed scan
[MENU]
Menu 2
F1 F2
Push [F-1] to select the scan menu.
Scan menu
1 ANT
1 3 5 7 9
S
Po
20 50
ALC
SWR
1 1.5 2 3
P. AMP
1
F2
F1
Push [F-1] to start/stop scan.
ABOUT FINE PROGRAMMED SCAN
F2
F1
Push [F3] to toggle between program scan and
fine program scan.
56
[TS] [V/M]
Mode keys
Tuning dial
F3 F4
USB
20 40 60
BLANK
100%
VFOA
AGC
S
F3 F4
F3 F4
Programmed scan searches for signals between scan
edge memory channels P1 and P2. The default fre-
quencies for these memories are 0.500000 MHz and
29.99999 MHz, respectively. See p. 56 for program-
ming scan edges.
Push [V/M] to select VFO mode, if necessary.
Push a mode key to select the desired operating
mode.
• Operating mode can also be selected during scan.
Push [TS] to select a tuning step.
• Tuning steps can also be selected during scan.
Push [MENU] to select
Push [F1] to select the scan menu.
Push [F1] to start/stop programmed scan.
• The MHz and kHz decimal points flash during scan.
• Rotating the tuning dial during scan cancels scan opera-
F5 tion.
CH
F5
During programmed scan, when a signal is received,
scan continues, but the tuning step is temporarily set
to 10 Hz.
Follow steps
scan.
During programmed scan, push [F3] to toggle be-
F5
tween programmed scan and
Push [F1] to stop the scan.
.
to above to start programmed
F scan operation.
: