F Scan And Fine F Scan; Scan Operation - Icom IC-746 Instruction Manual

8

SCAN OPERATION

8-5 F scan and Fine
:
[MENU]
Menu 2
F1 F2
Push [F-1] to select the scan menu.
Scan menu
1 ANT
1 3 5 7 9
S
Po
20 50
ALC
SWR
1 1.5 2 3
P. AMP
1
F1 F2
Push [F-3] to toggle between
ABOUT FINE
Scan menu
F1 F2
Push [F-3] to toggle between
and Fine
58
F scan
:
Key pad
[V/M]
Tuning dial [M-CH]
F3 F4
USB
20 40 60
100% VFOA
AGC
S
F3 F4
F scan and fine
:
F SCAN
:
F3 F4
:
F scan.
:
F scan searches on either side of the displayed
:
memory channel or frequency. The frequency range
searched on either side of the center frequency (mem-
ory channel) is specified by the span.
Push [V/M] to select memory mode or VFO mode,
as desired.
Push [MENU] to select
Push [F1] to select the scan menu.
Push [F4] one or more times to select the desired
span value.
• Selectable span values are ±5 kHz, ±10 kHz, ±20 kHz,
±50 kHz, ±100 kHz, ±500 kHz and ±1 MHz.
In VFO mode, use the keypad or tuning dial to set
the center frequency; in memory mode, rotate [M-
CH] to set the center frequency for memory chan-
nels.
Push [F2] to start/stop
• The MHz and kHz decimal points flash during
scan.
F5
• Rotating the tuning dial during scan cancels the
scan.
CH
F5
F scan.
:
This is the same as
nal is detected, the scan tuning becomes 10 Hz.
Follow steps
During
scan and fine
Push [F2] to cancel the scan.
F5
F scan
.
F scan.
:
F scan, except that when a sig-
:
to above to start
F scan, push [F3] to toggle between
:
F scan.
:
F scan.
:
F
: