Memory Channels; General; Memory Channel Selection - Icom IC-746 Instruction Manual

7-1 General

MEMORY
MEMORY
CHANNEL
CHANNEL
NUMBER
Regular
1–99
(split memory)
Scan edges
P1, P2
Call channel

7-2 Memory channel selection

Å IN VFO MODE
• VFO mode is selected
USB
1 ANT
1 3 5 7 9 20 40
S
Po
20 50
ALC
SWR
1 1.5 2 3
Disappears when a channel is programmed
CAPABILITY
Independent transmit and receive
frequencies and one mode in each
memory channel.
In addition, tone frequencies (or 1750
Hz tone burst) can also be stored for
repeater use.
One frequency and one mode in
each memory channel as scan edges
for programmed scan.
Same as regular.
C
[V/M] [M-CH]
60
BLANK
100% VFOA
CH

MEMORY CHANNELS

The transceiver has 101 memory channels (plus 1 call
channel). Memory mode is useful for quickly changing
often-used frequencies.
All 101 memory channels are tuneable, which means
the programmed frequency can be tuned temporarily
with the tuning dial in memory mode.
TRANSFER
TO VFO
Yes
Yes
No
Push [V/M] to select VFO mode, if necessary, then
rotate [M-CH] to select a memory channel number.
• All memory channels including blank channels can be
selected.
• "BLANK" appears when no information has been pro-
grammed into a memory channel.
Push [V/M] to select memory mode.
• "MEMO" and the contents of the memory channel ap-
pear.
• M-CH 2 is selected in VFO, then memory mode is
selected
1 ANT
1 3 5 7 9 20
S
Po
20 50
ALC
SWR
1 1.5 2 3
OVER-
CLEAR
WRITING
Yes Yes
Yes No
Yes No
CW
40 60
100%
MEMO CH
7
49